These chrome-plated metal power buttons are rugged and look great! Simply drill a 16mm hole into any material up to 13mm / ~1/2″ thick and you can fit these in place. The button is IP65 rated and there's even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a backlit plastic LED ring and inset power logo. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the backlight ring (+ and -). The contacts are compatible with our 1/8″ Quick Connects or can be directly soldered to.
This button is a single pole / dual throw (SPDT) on/off switch. When you press it the 'normally-open' contact shorts to the common contact and the button stays 'pressed'. When you press it a second time, the button springs open, and the contacts open up again. The backlight circuit is independent of the switch. Connect 5 to 6V to the LED to have it light up nicely, there's a built in resistor – no need to add one!
- Drill hole diameter: 16mm
- Switch contacts: 1 NO, 1 NC
- Protection: IP65
- Separate Lighting circuit
- Switch rating: 5A
- Material: Chrome-plated brass
- Panel thickness: 1-13mm
- Lamp rated voltage: 5-6V
This product has a 30 Day Warranty from the date of delivery. The item must not be modified, abused, incorrectly hooked up, or used for purposes outside the original scope of design.
This product is returnable Within 14 Days of delivery. Item must be unopened, unused, and in re-saleable condition.