Pre-Wired 1.8mm Warm White LED
Many model builders and hobbyists often wish if there were a smaller LED they could wire into their models for lighting effects. In the past, there were very few options for small lights, incandescent would get hot and burn out quite quickly and LEDs were large only available in limited colors.
With the advent of smaller electronic components used in our modern devices came new LEDs at increasingly smaller sizes. The trouble with these tiny LEDs was that they were meant to mount direct to a circuit board and were incredibly hard to handle.
These tiny 1.8mm LEDs are larger than our prewired SMD LEDs but still quite a bit smaller than most standard LEDs. Just like the SMD LEDs, these are pre-wired with two very fine wires – meaning these can be easily wired to any model boat, train, plane, car, spaceship or whatever else you may want to add tiny lights to. This specific version has a built in current limiting resistor and is designed to work with anywhere between 12 and 16V without additional circuitry.
The dome of this LED is 1.8mm in diameter with a height of 1.5mm. Behind the dome of the LED there is a larger base measuring 2.4 x 3.3mm where the wires and resistor are soldered in place.
- Current: 15 – 20mA
- Base Dimensions: 2.4 x 3.3mm
- Dome Height: 1.5mm
- Dome Diameter: 1.8mm
- Voltage: 12 – 16VDC
- Color: Warm White
- Pre-wired 1K Ohm Resistor
- Wire Length: 180mm
This product has a 30 Day Warranty from the date of delivery. The item must not be modified, abused, incorrectly hooked up, or used for purposes outside the original scope of design.
This product is Final Sale and cannot be returned once purchased.